Skip to content

Ready before summer heat. Free in-person consultation: (972) 853-9810

Scurry · Kaufman · Crandall · Combine

(972) 853-9810
Two installers tilting a new dark wood-grain entry door with leaded-glass sidelites into the front doorway of a brick house porch, a ladder leaning nearby

ServicesEntry Doors

Entry Doors in Scurry, TX

We replace worn or drafty front doors with fiberglass, steel or wood units, fitted square in the opening and sealed at the threshold. Plan the change for spring or fall, and your home heads into summer heat or a winter cold snap with a door that closes tight.

When a new entry door is the right call

A front door works harder than any window. It swings thousands of times a year, takes direct sun and rain, and carries a lockset and deadbolt that pull on the frame every day. Once the slab warps, the lower frame softens or the weatherstripping can no longer close the gap, another adjustment only buys a few months. Replacing the slab and frame together brings back a door that latches with a light push.

We fit prehung entry doors, so the slab, jamb, hinges and sill arrive as one squared system. That matters where clay soils move with wet and dry seasons and an old frame has often drifted out of plumb. We set the new unit level, shim it at the hinge and lock points, and seal it to the house so drafts and outside heat stay where they belong.

Timing helps. Mild weeks in spring and fall make a few hours with the opening exposed comfortable, and you go into the hardest months already sealed.

What your entry door project includes

Material and style guidance
At the consultation we put fiberglass, steel and wood side by side. Fiberglass handles sun and humidity well and can carry a convincing wood grain. Steel is strong and economical. Wood gives the warmest finish and asks for more upkeep.
Careful removal of the old door
We take out the existing slab and frame, then check the rough opening and subfloor for soft wood or water damage. You see what we find before anything else happens.
Prehung installation, set plumb
The new unit is shimmed, fastened through the jamb into solid framing and checked for an even gap along the full height of the slab.
Threshold and weather sealing
We set the sill on a bed of sealant, adjust the threshold to meet the door sweep, and fill around the frame with low-expansion foam so the jamb stays straight.
Hardware, trim and finish
Locksets, deadbolts and strike plates are installed and tested. Interior trim is fitted and caulked, and the exterior brickmold is sealed against rain.
Cleanup and walkthrough
We cover floors along the work path, haul away the old door and show you how the hinges, lock and threshold adjust.

Signs your front door is ready to be replaced

  • Light or air around the edges

    Daylight at a top corner or a draft at the latch side means the seal has failed or the frame has moved.

  • Sticking or dragging

    A door that rubs at the head or drags on the sill, especially as the seasons turn, usually sits in a frame that is out of square.

  • Soft wood at the bottom of the frame

    Rain splashing at the threshold rots the lower jamb and sill first. If the wood gives under a firm thumb, the frame is past saving.

  • A lock you have to coax

    When you pull the door toward you just to turn the deadbolt, the bolt and strike no longer line up, and the door is less secure than it should be.

  • A tired slab

    Steel rusts at dents, wood splits and peels under strong sun, and older hollow slabs do little to hold back heat or cold.

How your entry door project runs

  1. 1

    Free in-person consultation

    We bring door and finish samples to your house, take careful measurements of the opening and check the frame and threshold up close. Afterward you get a written quote with the door, the hardware and the labor each priced on separate lines.

  2. 2

    Confirming and ordering

    Almost all entry doors are built to order. We confirm the size, swing direction, glass and finish with you before the order goes in, and we set your install date once the door arrives.

  3. 3

    Installation day

    Most single doors take one day. We plan the work so the opening is closed in and the door locks before the crew leaves.

  4. 4

    Final check together

    You and our crew test the swing, the latch and the seal together, and we leave care notes for the finish. Your door carries our limited lifetime warranty on labor and product, and it transfers to the next owner when you sell.

Estimator crouching beside a homeowner, pointing at a cracked pane in a white window on a brick house wall, with a ladder, tool bag and drill nearby

What shapes the price of an entry door

An entry door is priced from the measurements we take and the choices you make, so your written quote comes after the consultation, with each part on its own line. If spreading the cost suits you better, ask about our 0% Financing options. We also offer $0 Down on the whole project.

Door material and finish
Fiberglass, steel and wood sit at different points, and grain texture or a factory stain moves the price within each.
Glass, sidelites and transoms
Decorative or insulated glass, and extra panels beside or above the door, add material and fitting time.
Size and opening changes
Standard openings are the simplest to fit. Taller doors, double doors or a widened opening add framing work.
Condition under the old door
Rotted sill plates or subfloor found during removal must be fixed before the new unit goes in. We photograph it and price it with you before doing that work.
Hardware
Handle sets, smart locks and multipoint locking systems range widely, and we show you options at each level.

Entry door questions

Something not covered here? (972) 853-9810

Afternoon sun hits my front door. Should I pick fiberglass or steel?

Usually fiberglass. It resists dents and rust, holds paint or stain well, and insulates better than most steel. Steel remains a good fit for a shaded entry or a tighter budget, and you can see both at the consultation.

Can you put a new door into my existing frame?

We install complete prehung units instead. An old frame, especially one that has shifted, rarely seals well around a new slab. Replacing the frame too gives you an even gap all around and a fresh threshold.

How long will my doorway be open?

Only from the time the old door comes out until the new one is in place, usually a few hours. We work tidily and close up the opening before we go.

Do you carry insurance and offer a warranty?

We do both. Our crew is fully insured while at your home, and every door we put in has a limited lifetime warranty on labor and product that passes to the next owner if you sell.

When is the best time to replace an entry door?

Spring or fall, since mild days make a few open hours easy to live with. An early spring install closes up the entry before the heat, and a fall install gets you ready for the first cold snap.

Do you also handle patio and storm doors?

We do. A storm door over a new entry door shields its finish from sun and wind-blown rain, and a worn patio door is often worth replacing in the same job. Tell us all the doors on your list and we will look at each one in a single visit.

Two-story brick house with new black-framed windows still bearing stickers, a stepladder, bucket and drop cloth on the front walk under an overcast sky

Get your front door ready for the season ahead

We will measure the opening, bring samples and talk through finishes at your home in Scurry, Kaufman, Forney or nearby. The consultation is free, and you leave with a clear written quote.